HOW TO: MAKE A GRAVITY BONG
DIRECTIONS FOR MAKING A GRAVITY BONG
- Materials
- Cut it
- Poke it
- Thread it
- Fill it
- Suck it
STEP 1: MATERIALS
Materials needed: Two-liter plastic bottle or water bottle, scissors, and a bowl from a metal pipe. If you do not have a bowl handy, you can fashion one using hardware found in most garages (detailed instructions coming soon.)
STEP 2: CUT IT
Using the scissors, cut off the bottom of the bottle.
STEP 3: POKE IT
Poke a hole in the top of the lid or cap so that the bowl can be screwed in. Make sure that the bowl fits tightly.
STEP 4: THREAD IT
Thread the bowl into the cap and place the cap back onto the bottle.
STEP 5: FILL IT
Remove the cap and put the bottle into a bucket of water (or a tub, pool, etc.). Snap on the cap, hold the lighter to the bowl, and pull up on the bottle to draw the smoke in. (The bottom of the bottle must stay in the water.)
STEP 6: SUCK IT
Remove the cap again and place your lips over the opening. Push the bottle back into the water while inhaling. CAREFUL! This one’s a doozey.
BUD SAYS: CAUTION! Do not attempt to smoke from a gravity bong if you are new to smoking pot … it WILL kick your butt.